Vladimir small set browned

This helmet is made with a round scull cap and finished with a protector for the eyes. The cap itself is decorated with two metal bands crosswise and another along the bottom edge.The "Brillenhelmet" is mostly found with nothern people of the germanic tribes and can be used in reenacting vikings.Material: 1,2mm steelSize: up to 62cm circumferenceColour: blankWe recommend to wear a padded coif underneath to avoid scratches and bruises. This will maximize your comfort.

This pretty fibula is used as fastener for cloaks and capes, but can also be attached just for decoration. It is made of robust steel and therefore also suitable for slightly thicker fabrics like wool.Material: SteelDiameter small fibula: 8cmDiameter large fibula: 10cm

The toggle "Heimo" is made of horn, carefully sanded and polished. It is an ideal closure for bags and clothing. The counterpart is a loop made of leather or fabric. Material: BonesDimensions: 5 cm x 1 cm

The two-piece belt set "Schleswig" consists of a belt tongue and a long buckle. Made of brass and cast by hand, it is inspired by belt decorations of the Vikings. Suitable for belts from 1 cm to 1,5 cm wide Material: brasstongue dimensions: 1,3 cm x 6, 3 cmDimensions of the buckle: 2 cm x 7 cm  

With "Tinne" you get 8 brass nails - 1.6 mm round head pins made of solid brass MS-64 with a share of 64% copper and 36% zinc. Pins made of this alloy are very easy to shape when riveting and are thus ideal for attaching historic and fantastic fittings in medieval reenactment and LARP. Dimensions: 1.6 mm x 13 mm. Fix fittings and decorations with brass nails, how does that work? The fitting or decoration to be fastened is placed on the belt or pocket. Mark the required 2 mm holes in the desired places and punch the leather with an eel. Of course, using a pair of punch pliers is also possible, but the hole must not be too large then, because the leather is punched out and, as with the use of eels, can not contract again around the rivet. The head of the pin should of course be on the side that is visible later, the so-called "show side". Depending on the thickness of the material, shorten the brass pin on the pointed side to 1.5 mm - 2 mm and tap it in circular strokes with the smallest possible round hammer, so that a slightly arched head is formed and the fitting is solidly connected to the backing material. For smoothing a sandpaper with 600er Körning is recommended. For a better grip, you can also use a small washer, but the riveting is then not so medieval. Have fun crafting!